Parker Transair 2019

89 3.5" 6" 5-10 N.m 1 2 5 / 10 N.m 3.5" 6" 5-10 N.m 4 3 DRILLING TOOL FOR ALUMINIUM PIPE 6698 02 02 FOR Ø25 AND 6698 02 01 FOR Ø40, Ø50 AND Ø63. DRILLING JIG FOR ALUMINIUM PIPE 6698 01 03 DEBURRING TOOL FOR ALUMINIUM PIPE 6698 04 02 PERMANENT MARKER PEN DRILL 1 - Mark the pipe at the desired position for the bracket, using the same locator mark when several take-off points need to be aligned uniformly. Place the drilling jig ref. 6698 01 03 in a vice or on the floor. To drill a Ø40 hole, remove the retaining bolt in the jig using an allen key and place the pipe in the jig. The locator mark on the pipe should be aligned with the appropriate guide marks on the side of the jig. Two guide lines on either side of the jig provide a rapid indication of whether the pipe is correctly positioned (the guide lines match the locator marks on the pipe). Close the jig and drill a hole using the appropriate drilling tool: • Ø25: Ø16 hole > ref. 6698 02 02 drilling tool • Ø40 - Ø50 - Ø63: Ø 22 hole >ref. 6698 02 01 drilling tool Recommended rotation speed: 650 rpm NB: drill without lubrication. 2 - Release the pipe, deburr and remove any swarf and the cut circular piece of pipe. Repeat the operation for the number of brackets that you wish to fit. 3 - Position the quick assembly bracket using its location pin. 4 - Tighten the nut with an Allen key 5mm. TOOLS REQUIRED PROCEDURE Fitting a Quick Assembly Bracket TO Ø 25 Ø 40 Ø 50 Ø 63 PIPE Installation Guide